Article Sidebar

Download
PDF
Statistic
Read Counter : 671 Download : 406

Downloads

Download data is not yet available.

Main Article Content

Abstract

The current study's sole objective is to evaluate the impact of hexane's addition to blends of diesel, waste plastic fuel, and jatropha biodiesel. Five fuel samples have been made in order to do this, including diesel-waste plastic fuel-jatropha biodiesel (D70WPF20JB10 and D70WPF10JB20), diesel-hexane-waste plastic fuel-jatropha biodiesel (D65HX5WPF20JB10 and D65HX5WPF10JB20), and plain diesel (D100) as a reference fuel. Following thorough characterization, studies using spectroscopic techniques such as FTIR, elemental analysis, and GC-MS are conducted. Finally, performance and emission tests on a direct-injection single-cylinder diesel engine were conducted. The density, flash point, and acid value of the diesel-waste plastic fuel-jatropha biodiesel blend are observed to decrease with the addition of hexane. With the addition of hexane, the calorific value and diesel index of the fuel both rise by 0.86% and 12.5%, respectively. In the case of the hexane mix fuel samples, it is discovered that the brake thermal efficiency and volumetric efficiency are higher and the brake-specific fuel consumption is lower. Hexane is added to the diesel-waste plastic fuel-jatropha biodiesel mixture, which results in a 34 percent rise in HC emissions and a 9 percent decrease in CO emissions. Additionally, it lowers by 8% and 15%, respectively, the temperature of the exhaust gas and the fuel's NOx emissions. The fuel sample with code D65HX5WPF10JB20 exhibits the best results among all the fuel samples in terms of performance and emission analyses.

Keywords

Engine performance Alternate fuel Emission Diesel Biodiesel Waste plastic fuel

Article Details

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

References

  1. A. Nadolny, C. Cheng, B. Lu, A. Blakers, and M. Stocks, “Fully electrified land transport in 100% renewable electricity networks dominated by variable generation,” Renewable Energy, vol. 182, pp. 562–577, 2022.
  2. P. V Elumalai et al., “Artificial neural networks model for predicting the behavior of different injection pressure characteristics powered by blend of biofuel‐nano emulsion,” Energy Science & Engineering, 2022.
  3. P. Shrivastava, T. N. Verma, O. D. Samuel, and A. Pugazhendhi, “An experimental investigation on engine characteristics, cost and energy analysis of CI engine fuelled with Roselle, Karanja biodiesel and its blends,” Fuel, vol. 275, p. 117891, 2020.
  4. M. Shekofteh, T. M. Gundoshmian, A. Jahanbakhshi, and A. Heidari-Maleni, “Performance and emission characteristics of a diesel engine fueled with functionalized multi-wall carbon nanotubes (MWCNTs-OH) and diesel–biodiesel–bioethanol blends,” Energy Reports, vol. 6, pp. 1438–1447, 2020.
  5. F. Yaşar, “Comparision of fuel properties of biodiesel fuels produced from different oils to determine the most suitable feedstock type,” Fuel, vol. 264, p. 116817, 2020.
  6. O. D. Samuel and M. Gulum, “Mechanical and corrosion properties of brass exposed to waste sunflower oil biodiesel-diesel fuel blends,” Chemical Engineering Communications, vol. 206, no. 5, pp. 682–694, 2019.
  7. Ö. Cihan, “Experimental and numerical investigation of the effect of fig seed oil methyl ester biodiesel blends on combustion characteristics and performance in a diesel engine,” Energy Reports, vol. 7, pp. 5846–5856, 2021.
  8. P. V Elumalai et al., “Effect of injection timing in reducing the harmful pollutants emitted from CI engine using N-butanol antioxidant blended eco-friendly Mahua biodiesel,” Energy Reports, vol. 7, pp. 6205–6221, 2021.
  9. A. Senatore, M. Cardone, V. Rocco, and M. V. Prati, “A comparative analysis of combustion process in DI diesel engine fueled with biodiesel and diesel fuel,” SAE Technical Paper, 2000.
  10. L. G. Schumacher, S. C. Borgelt, D. Fosseen, W. Goetz, and W. G. Hires, “Heavy-duty engine exhaust emission tests using methyl ester soybean oil/diesel fuel blends,” Bioresource Technology, vol. 57, no. 1, pp. 31–36, 1996.
  11. M. Canakci, “Combustion characteristics of a turbocharged DI compression ignition engine fueled with petroleum diesel fuels and biodiesel,” Bioresource technology, vol. 98, no. 6, pp. 1167–1175, 2007.
  12. D. Y. Z. Chang, J. H. Van Gerpen, I. Lee, L. A. Johnson, E. G. Hammond, and S. J. Marley, “Fuel properties and emissions of soybean oil esters as diesel fuel,” Journal of the American Oil Chemists’ Society, vol. 73, no. 11, pp. 1549–1555, 1996.
  13. G. Knothe and K. R. Steidley, “Kinematic viscosity of biodiesel fuel components and related compounds. Influence of compound structure and comparison to petrodiesel fuel components,” Fuel, vol. 84, no. 9, pp. 1059–1065, 2005.
  14. C. D. Rakopoulos, K. A. Antonopoulos, D. C. Rakopoulos, D. T. Hountalas, and E. G. Giakoumis, “Comparative performance and emissions study of a direct injection diesel engine using blends of diesel fuel with vegetable oils or bio-diesels of various origins,” Energy conversion and management, vol. 47, no. 18–19, pp. 3272–3287, 2006, doi: 10.1016/j.enconman.2006.01.006.
  15. D. Damodharan, A. P. Sathiyagnanam, D. Rana, B. R. Kumar, and S. Saravanan, “Extraction and characterization of waste plastic oil (WPO) with the effect of n-butanol addition on the performance and emissions of a DI diesel engine fueled with WPO/diesel blends,” Energy conversion and management, vol. 131, pp. 117–126, 2017.
  16. R. L. McCormick, M. S. Graboski, T. L. Alleman, A. M. Herring, and K. S. Tyson, “Impact of biodiesel source material and chemical structure on emissions of criteria pollutants from a heavy-duty engine,” Environmental science & technology, vol. 35, no. 9, pp. 1742–1747, 2001.
  17. S. Ellappan and B. Pappula, “Utilization of unattended waste plastic oil as fuel in low heat rejection diesel engine,” Sustainable Environment Research, vol. 29, no. 1, pp. 1–9, 2019.
  18. S. Sunaryo, P. A. Sesotyo, E. Saputra, and A. P. Sasmito, “Performance and Fuel Consumption of Diesel Engine Fueled by Diesel Fuel and Waste Plastic Oil Blends: An Experimental Investigation,” Automotive Experiences, vol. 4, no. 1, pp. 20–26, 2021, doi: 10.31603/ae.3692.
  19. R. Thahir, A. Altway, and S. R. Juliastuti, “Production of liquid fuel from plastic waste using integrated pyrolysis method with refinery distillation bubble cap plate column,” Energy reports, vol. 5, pp. 70–77, 2019.
  20. I. Fahim, O. Mohsen, and D. ElKayaly, “Production of fuel from plastic waste: a feasible business,” Polymers, vol. 13, no. 6, p. 915, 2021.
  21. N. Karisathan Sundararajan and A. Ramachandran Bhagavathi, “Experimental investigation on thermocatalytic pyrolysis of HDPE plastic waste and the effects of its liquid yield over the performance, emission, and combustion characteristics of CI engine,” Energy & Fuels, vol. 30, no. 7, pp. 5379–5390, 2016.
  22. M. Mani and G. Nagarajan, “Influence of injection timing on performance, emission and combustion characteristics of a DI diesel engine running on waste plastic oil,” Energy, vol. 34, no. 10, pp. 1617–1623, 2009.
  23. M. Mani, G. Nagarajan, and S. Sampath, “An experimental investigation on a DI diesel engine using waste plastic oil with exhaust gas recirculation,” Fuel, vol. 89, no. 8, pp. 1826–1832, 2010.
  24. M. Mani, G. Nagarajan, and S. Sampath, “Characterisation and effect of using waste plastic oil and diesel fuel blends in compression ignition engine,” Energy, vol. 36, no. 1, pp. 212–219, 2011.
  25. P. Mohammadi, A. M. Nikbakht, M. Tabatabaei, and K. Farhadi, “A novel diesel fuel additive to improve fuel properties and to reduce emissions,” Automotive Science and Engineering, vol. 2, no. 3, pp. 156–162, 2012.
  26. C. BAYINDIRLI, M. CELİK, M. Demiralp, and O. R. S. İlker, “Investigation of effect of n-hexane additives in biodiesel on combustion and exhaust emissions in diesel engines,” International Journal of Automotive Engineering and Technologies, vol. 6, no. 3, pp. 140–147, 2017.
  27. B. P. Pundir, IC engines: combustion and emissions. Alpha Science International, 2010.
  28. R. Van Basshuysen and F. Schäfer, Internal combustion engine handbook-basics, components, systems and perspectives, vol. 345. 2004.
  29. P. K. Sahoo and L. M. Das, “Combustion analysis of Jatropha, Karanja and Polanga based biodiesel as fuel in a diesel engine,” Fuel, vol. 88, no. 6, pp. 994–999, 2009.
  30. F. Wu, J. Wang, W. Chen, and S. Shuai, “A study on emission performance of a diesel engine fueled with five typical methyl ester biodiesels,” Atmospheric environment, vol. 43, no. 7, pp. 1481–1485, 2009.
  31. R. E. Pauls, “A review of chromatographic characterization techniques for biodiesel and biodiesel blends,” Journal of chromatographic science, vol. 49, no. 5, pp. 384–396, 2011.
  32. M. Sarker, M. M. Rashid, and M. Molla, “New alternative vehicle hydrocarbon liquid fuels from municipal solid waste plastics,” Journal of Fundamentals of Renewable Energy and Applications, vol. 1, 2011.
  33. B. S. Chauhan, N. Kumar, Y. Du Jun, and K. B. Lee, “Performance and emission study of preheated Jatropha oil on medium capacity diesel engine,” Energy, vol. 35, no. 6, pp. 2484–2492, 2010.
  34. S. Bajpai and L. M. Das, “Feasibility of utilization of Fatty Acid Ethyl Esters-Diesel blends as an act to fatty acid methyl esters-Diesel blend,” in Proceedings of the 7th international conference of Biofuels organized by Winrock international, 2010, pp. 91–100.
  35. A. K. Agarwal and K. Rajamanoharan, “Experimental investigations of performance and emissions of Karanja oil and its blends in a single cylinder agricultural diesel engine,” Applied energy, vol. 86, no. 1, pp. 106–112, 2009.
  36. S. Puhan, N. Vedaraman, G. Sankaranarayanan, and B. V. B. Ram, “Performance and emission study of Mahua oil (madhuca indica oil) ethyl ester in a 4-stroke natural aspirated direct injection diesel engine,” Renewable energy, vol. 30, no. 8, pp. 1269–1278, 2005.
  37. Ş. Altun, H. Bulut, and C. Öner, “The comparison of engine performance and exhaust emission characteristics of sesame oil–diesel fuel mixture with diesel fuel in a direct injection diesel engine,” Renewable Energy, vol. 33, no. 8, pp. 1791–1795, 2008.
  38. C.-W. Wu, R.-H. Chen, J.-Y. Pu, and T.-H. Lin, “The influence of air–fuel ratio on engine performance and pollutant emission of an SI engine using ethanol–gasoline-blended fuels,” Atmospheric Environment, vol. 38, no. 40, pp. 7093–7100, 2004.
  39. B. Venkanna, C. V. Reddy, and S. B. Wadawadagi, “Performance, emission and combustion characteristics of direct injection diesel engine running on rice bran oil/diesel fuel blend,” diesel engine, vol. 14, p. 15, 2009.
  40. D. N. Mallikappa, R. Reddy, and C. S. N. Murthy, “Performance and emission characteristics studies on stationary diesel engines operated with cardanol biofuel blends,” International journal of renewable energy research, vol. 2, no. 2, pp. 295–299, 2012.
  41. S. K. Hoekman and C. Robbins, “Review of the effects of biodiesel on NOx emissions,” Fuel Processing Technology, vol. 96, pp. 237–249, 2012.
  42. H. Jääskeläinen and W. A. Majewski, “Effects of biodiesel on emissions,” dieselnet.com, 2021. https://dieselnet.com/tech/fuel_biodiesel_emissions.php.
  43. M. N. Nabi, S. M. N. Hoque, and M. S. Akhter, “Karanja (Pongamia Pinnata) biodiesel production in Bangladesh, characterization of karanja biodiesel and its effect on diesel emissions,” Fuel processing technology, vol. 90, no. 9, pp. 1080–1086, 2009.