Article Sidebar

Download
PDF
Statistic
Read Counter : 1822 Download : 662

Downloads

Download data is not yet available.

Main Article Content

Abstract

The purpose of this study was to examine the addition of air mass flow rate into the combustion chamber using E30 emulsion fuel (Water 70% + Dex 30% + 2% surfactant tween 80 + span 80 ) on a Diamond DI 800 stationary diesel engine with an engine rotation of 1500 rpm. Characteristics evaluated using Combustion Analyze, and emissions measured with a Gas Analyzer. The results showed the addition of air mass flow rate affected engine performance and emissions with the engine power observed to have decreased by 0.016% while SFC and thermal efficiency increased by 2,077% and 33,053% respectively compared to diesel fuel. Moreover, the BMEP and exhaust temperature also decreased with the most optimum in BMEP found to be 0.02% and exhaust temperature at 285°C while diesel has 358°C. The analysis of the combustion process for E30 emulsion fuel with variations in the air mass flow rate added showed the peak cylinder pressure at high loads was at 0.018 kg/s at a pressure of 5.86 bar. Meanwhile, the optimum heat release rate at high loads was obtained at a variation of 0.013 kg/s. This, therefore, means adding air mass flow rate to the E30 emulsion fuel has the ability to improve performance and reduce engine emissions.

Keywords

Diesel engine Mass flow rate Emulsion` BMEP

Article Details

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Author Biographies

Rosid Rosid, Universitas Singaperbangsa Karawang, Indonesia

Academic profile: Scopus; ORCID; Google Scholar; ResearchGate; Sinta

Bambang Sudarmanta, Institut Teknologi Sepuluh Nopember Surabaya, Indonesia

Academic profile: Scopus; ORCID; Google Scholar; ResearchGate; Sinta

Lukman Atmaja, Institut Teknologi Sepuluh Nopember Surabaya, Indonesia

Academic profile: Scopus; ORCID; Google Scholar; ResearchGate; Sinta

Salih Özer, Mus Alparslan University, Turkey

Academic profile: Scopus; ORCID; Google Scholar; ResearchGate; Publons

References

  1. R. K. Pachauri And L. Meyer, Climate Change 2014: Synthesis Report. Contribution Of Working Groups I, Ii And Iii To The Fifth Assessment Report Of The Ipcc. 2015.
  2. M. Yahaya Khan, Z. A. Abdul Karim, F. Y. Hagos, A. R. A. Aziz, And I. M. Tan, “Current Trends In Water-In-Diesel Emulsion As A Fuel,” Sci. World J., Vol. 2014, No. January, 2014, Doi: 10.1155/2014/527472.
  3. J. Sadhik Basha And R. B. Anand, “An Experimental Investigation In A Diesel Engine Using Carbon Nanotubes Blended Water-Diesel Emulsion Fuel,” Proc. Inst. Mech. Eng. Part A J. Power Energy, Vol. 225, No. 3, Pp. 279–288, 2011, Doi: 10.1177/2041296710394247.
  4. M. T. Ghannam And M. Y. E. Selim, “Stability Behavior Of Water-In-Diesel Fuel Emulsion,” Pet. Sci. Technol., Vol. 27, No. 4, Pp. 396–411, 2009, Doi: 10.1080/10916460701783969.
  5. M. R. Noor El-Din, S. H. El-Hamouly, H. M. Mohamed, M. R. Mishrif, And A. M. Ragab, “Water-In-Diesel Fuel Nanoemulsions: Preparation, Stability And Physical Properties,” Egypt. J. Pet., Vol. 22, No. 4, Pp. 517–530, 2013, Doi: 10.1016/J.Ejpe.2013.11.006.
  6. Rosid, B. Sudarmanta, L. Atmaja, I. S. Krisandika, And A. W. Arohman, “Effect Of 35% Water In Diesel Emulsion Fuel And Afr Enriched Combustion On The Combustion And Emissions Characteristics,” Aip Conf. Proc., Vol. 2187, No. December, 2019, Doi: 10.1063/1.5138301.
  7. B. Sudarmanta, Rosid, I. S. Krisandika, And A. W. Arohman, “The Effect Of Advancing Injection Timing On Combustion Characteristics Using Stationary Diesel Engine With 30% Water In Diesel Emulsion Fuel,” Aip Conf. Proc., Vol. 2187, No. December, 2019, Doi: 10.1063/1.5138298.
  8. A. W. Arohman, B. Sudarmanta, And Rosid, “Influence Of Water Diesel Emulsion On The Performance And Emission Diesel Engine Under Varying Engine Load,” Aip Conf. Proc., Vol. 2187, No. December, 2019, Doi: 10.1063/1.5138267.
  9. H. Kim And S. W. Baek, “Combustion Of A Single Emulsion Fuel Droplet In A Rapid Compression Machine,” Energy, Vol. 106, Pp. 422–430, 2016, Doi: 10.1016/J.Energy.2016.03.006.
  10. C. Y. Lin And K. H. Wang, “Diesel Engine Performance And Emission Characteristics Using Three-Phase Emulsions As Fuel,” Fuel, Vol. 83, No. 4–5, Pp. 537–545, 2004, Doi: 10.1016/J.Fuel.2003.08.012.
  11. D. T. Hountalas, G. C. Mavropoulos, T. C. Zannis, And S. D. Mamalis, “Use Of Water Emulsion And Intake Water Injection As Nox Reduction Techniques For Heavy Duty Diesel Engines,” Sae Tech. Pap., Vol. 2006, No. 724, 2006, Doi: 10.4271/2006-01-1414.
  12. I. S. Krisandika, B. Sudarmanta, And Rosid, “Effects Of Advancing Injection Timing On The Engine Performances And Emissions Of A Diesel Engine With 35% Water In Diesel Emulsion Fuel,” Aip Conf. Proc., Vol. 2187, No. December, 2019, Doi: 10.1063/1.5138261.
  13. A. M. Ithnin, M. A. Ahmad, M. A. A. Bakar, S. Rajoo, And W. J. Yahya, “Combustion Performance And Emission Analysis Of Diesel Engine Fuelled With Water-In-Diesel Emulsion Fuel Made From Low-Grade Diesel Fuel,” Energy Convers. Manag., Vol. 90, Pp. 375–382, 2015, Doi: 10.1016/J.Enconman.2014.11.025.
  14. K. A. Subramanian, “A Comparison Of Water-Diesel Emulsion And Timed Injection Of Water Into The Intake Manifold Of A Diesel Engine For Simultaneous Control Of No And Smoke Emissions,” Energy Convers. Manag., Vol. 52, No. 2, Pp. 849–857, 2011, Doi: 10.1016/J.Enconman.2010.08.010.
  15. D. Maji, P. Mondal, And B. Kumar Mandal, “Experimental Investigation On The Use Of Water Emulsified Diesel In A Single Cylinder Compression Ignition Engine,” Iop Conf. Ser. Mater. Sci. Eng., Vol. 377, No. 1, 2018, Doi: 10.1088/1757-899x/377/1/012123.
  16. M. E. A. Fahd, Y. Wenming, P. S. Lee, S. K. Chou, And C. R. Yap, “Experimental Investigation Of The Performance And Emission Characteristics Of Direct Injection Diesel Engine By Water Emulsion Diesel Under Varying Engine Load Condition,” Appl. Energy, Vol. 102, Pp. 1042–1049, 2013, Doi: 10.1016/J.Apenergy.2012.06.041.
  17. J. B. Heywood, Internal Combustion Engine Fundamentals. New York: Mcgraw Hill Book Company, 1988.
  18. R. G. Papagiannakis, C. D. Rakopoulos, D. T. Hountalas, And D. C. Rakopoulos, “Emission Characteristics Of High Speed, Dual Fuel, Compression Ignition Engine Operating In A Wide Range Of Natural Gas/Diesel Fuel Proportions,” Fuel, Vol. 89, No. 7, Pp. 1397–1406, 2010, Doi: 10.1016/J.Fuel.2009.11.001.
  19. Q. Nguyen And Y. Wu, “Experimental Investigations Of Using Water-Gasoline Emulsions As A Nox Treatment And Its Effects On Performance And Emissions Of Lean-Burn Spark-Ignition Engine,” Int. Conf. Power Eng., Vol. 09, 2009.
  20. G. Chen And D. Tao, “An Experimental Study Of Stability Of Oil-Water Emulsion,” Fuel Process. Technol., Vol. 86, No. 5, Pp. 499–508, 2005, Doi: 10.1016/J.Fuproc.2004.03.010.
  21. I. Yorobiev Ya., V. M. Zharnov, And V. D. Naumenko, Internal Combustion Engine. 1985.
  22. R. Rosid, “Analisa Proses Pembakaran Pada Motor Bensin 113.5 Cc Dengan Simulasi Ansys,” J. Teknol., Vol. 8, No. 2, P. 89, 2016, Doi: 10.24853/Jurtek.8.2.89-93.
  23. Rosid, “Analisis Proses Pembakaran Sistem Injection Pada Sepeda Motor Dengan Menggunakan Bahan Bakar Premium Dan Pertamax,” J. Teknol., Vol. 7, No. 2, Pp. 86–92, 2015.
  24. J. W. Park, K. Y. Huh, And J. H. Lee, “Reduction Of Nox, Smoke And Brake Specific Fuel Consumption With Optimal Injection Timing And Emulsion Ratio Of Water-Emulsified Diesel,” Proc. Inst. Mech. Eng. Part D J. Automob. Eng., Vol. 215, No. 1, Pp. 83–93, 2001, Doi: 10.1243/0954407011525476.
  25. P. Endah, R. Rosid, And S. Faizal, “Comparison Thermal Efficiency And Fuel Consumption Of Electric Supercharger Variations For Otto Engine,” J. Appl. Sci. Adv. Technol., Vol. 1, No. 2, Pp. 63–68.